Juniper QFX5100, Руководство по оборудованию

Страница: 199 / 256

Related
Documentation
Console Port Connector Pinouts for the QFX Series on page 56
•
Connecting a QFX5100 Switch to a Network for Out-of-Band Management
You can monitor and manage the QFX5100 device using a dedicated management
channel. QFX5100 devices have a minimum of two management ports:
a 10/100/1000BASE-T RJ-45 port and a 1-Gbps SFP ports. Some product SKUs have an
additional 1-Gbps SFP port that can be used either for fiber or copper connections. Use
the management ports to connect the QFX5100 device to a network for out-of-band
management.
CAUTION: Configuring the two management interfaces within the same
subnet is not supported.
NOTE: You cannot use the management ports to perform the initial
configuration of the QFX5100 device. You must configure the management
ports before you can successfully connect to the QFX5100 switch using these
ports. See
“Configuring a QFX5100 Switch” on page 185 .
Ensure that you have an appropriate cable available. See “Cable Specifications for Console
and Management Connections for the QFX Series” on page 91 and “Interface
Specifications for SFP, SFP+, and QSFP+ Transceivers for the QFX Series” on page 61
To connect a QFX5100 switch to a network for out-of-band management (see
Figure 46 on page 182 ):
1.
Connect one end of the cable to one of the management ports (labeled C0 and
C1 ) on the QFX5100 switch.
2.
Connect the other end of the cable to the management switch (see
Figure 46 on page 182 ).
181 Copyright © 2014, Juniper Networks, Inc.
Chapter 17: Connecting the QFX5100 Device