Juniper NETWORK AND SECURITY MANAGER NSM3000 - REV 1, Руководство пользователя

Страница: 37 / 100

the NSM superuser (also referred to as the NSM administrator). This user has the
highest level of privilege in NSM.
• GUI Server one-time password—Enter 3 to specify this password. This password
authenticates this server to its peers in a high-availability configuration, and to the
central manager.
• NSM License type [Base Install]—Enter 4 to specify the license option. Enter Base
Install to use the built-in limited device license for as many as 25 devices. This option
is the default. Otherwise, enter the filename of the license file you purchased from
Juniper Networks that permits you to manage more than 25 devices.
For additional details about NSM licensing, see the Network and Security Manager
Installation Guide .
Configuring Custom Settings
This section describes the custom options that are available for a regional server
configuration. The custom options include the typical options described in the previous
section as well as the following two options:
5> Menu: High Availability [Off]
6> Menu: Advanced Options
You have the following options:
• High Availability—Enter 5 to open a menu to configure HA.
• Advanced Options—Enter 6 to open a menu of additional configurable options, including
the port number for receiving messages through the NSM API, remote database
replication details, and the Statistical Report Server (SRS).
The following sections provide details about these options:
•
Configuring High Availability on page 17
• Configuring Advanced Options on page 19
Configuring High Availability
NOTE: When installing NSM regional server in a high availability configuration
with a shared disk, you must first revert the system to factory default values
using the boot menu. See “The NSM Appliance Default Restoration” on
page 29 for details.
The following options are available to configure high availability (HA) on the regional
server.
•
High Availability—Enter 1 to turn HA on or off.
•
Primary Status—Enter 2 to specify the NSM appliance as either the primary or secondary
server. At the next prompt, enter y for the primary server. Enter n for a secondary server.
• HA Remote IP—Enter 3 to specify the IP address for the HA peer in the HA cluster.
17 Copyright © 2010, Juniper Networks, Inc.
Chapter 2: Installing and Configuring NSM from the CLI