Juniper NETWORK AND SECURITY MANAGER NSM3000 - REV 1, Руководство пользователя

Страница: 26 / 100

To install NSMXpress:
1.
Place the shipping container on a flat surface and remove the hardware components
with care.
2.
Remove the NSMXpress device from the shipping container and place it on a flat
surface.
3.
Mount NSMXpress in your server rack using the attached mounting brackets.
4.
Plug the power cord into the AC receptacle on the rear panel.
If your NSMXpress contains two power supplies, plug a power cord into each AC
receptacle.
5.
Plug the other end of the power cord into a wall socket.
If your NSMXpress contains two power supplies, plug each power cord into a separate
power circuit to ensure that the NSMXpress continues to receive power if one of the
power circuits fails.
6.
Plug the Ethernet cable into the port marked ETH0 on the front panel. See Figure 3
on page 8.
Figure 1: Front Panel of NSMXpress
7.
Plug the null modem serial cable into the console port. See Figure 3 on page 8.
This cable was shipped with your NSMXpress. If you do not have this cable, use any
other null modem serial cable.
8.
Push the power button in the upper left corner of the front panel.
The green LED below the power button turns on. The NSMXpress hard disk LED turns
on whenever the appliance reads data from or writes data to an NSMXpress hard disk.
The internal port uses two LEDs to indicate the LAN connection status, which is
described in Table 6 on page 6.
Hardware installation is now complete. The next step is to set up the software, as
described in “Initial Setup Configuration” on page 8.
Table 6 on page 6 provides LED information for the Ethernet ports.
Table 6: Ethernet Port LEDs
LED2 LED 1 LAN Status
Off Off 10 Mbps connection
Copyright © 2010, Juniper Networks, Inc. 6
NSMXpress and NSM3000 User Guide