Juniper NetScreen-25, Руководство пользователя

Страница: 26 / 36

Chapter 3 Configuring the Device
20 User’s Guide
3. Press the y key.
The following message appears:
!! Reconfirm Lost Password Reset !! If you continue, the entire configuration of
the device will be erased. In addition, a permanent counter will be incremented to
signify that this device has been reset. This is your last chance to cancel this
command. If you proceed, the device will return to factory default configuration,
which is: System IP: 192.168.1.1; username: netscreen; password: netscreen.
Would you like to continue? y/[n]
4. Press the y key to reset the device.
You can now login in using netscreen as the default admin name and password.
8VLQJWKH$VVHW5HFRYHU\3LQKROHWR5HVHWWKH'HYLFH
You can also reset the device and restore the factory default settings by pressing the asset
recovery pinhole. To perform this operation, you need to make a console connection, as
described in
“Connecting Using a vt100 Terminal Emulator” on page 15 .
1. Locate the asset recovery pinhole on the front panel. Using a thin, firm wire
(such as a paper clip), push the button located behind the asset recovery pinhole
for four to six seconds.
A serial console message states that the “Configuration Erasure Process has
been initiated” and the system sends an SNMP/SYSLOG alert. The Status LED
blinks amber once every second.
After the first reset is accepted, the power LED blinks green. The serial console
message now reads, “Waiting for 2nd confirmation.”
2. Release the button for one second.
3. Push the button again for four to six seconds. A serial console message states
“Second push has been confirmed.”
The Status LED lights amber for one-half second, then returns to the blinking
green state.
Continue to press the button until the message “Configuration Erase sequence
accepted, unit reset.” The system generates SNMP and SYSLOG alerts to
configured SYSLOG or SNMP trap hosts.
Note: During a reset, there is no guarantee that the final SNMP alert sent to the
receiver before the reset will be received.
Asset Recovery Pinhole