Juniper NetScreen-25, Руководство пользователя

Страница: 21 / 36

Performing Initial Configuration Using the CLI
NetScreen-25 15
6. Flip the power switch to the ON position.
7. After the NetScreen-25 device restarts, check the following LEDs:
– The Power LED glows green.
– The Status-1 LED blinks green.
– The Ethernet port LEDs for each connected interface glow or blink green.
(For more details about interpreting the port LEDs, see
“Ethernet
Interfaces” on page 5 .)
3
(5)250,1*
,
1,7,$/
&
21),*85$7,21
8
6,1* 7+(
&/,
There are two ways to establish a console session with the NetScreen-25 device:
• Using a vt100 terminal emulator, such as Hilgraeve
®
Hyperterminal
®
, t
hrough
an RJ-45 serial cable connected to the console port.
• Using Telnet through a TCP/IP network connection to the NetScreen-25 device.
&RQQHFWLQJ8VLQJDYW7HUPLQDO(PXODWRU
To establish a connection to the NetScreen-25 device using a vt100 Terminal Emulator:
1. Connect an RJ-45 serial cable between the console port on the NetScreen-25
device and the serial port on your computer.
2. Start the vt100 terminal emulator program on your computer.
Typical settings for a console session are as follows:
• Baud Rate to 9600
• Parity to No
• Data Bits to 8
• Stop Bit to 1
• Flow Control to none
3. Press the ENTER key to see the login prompt.
4. At the login prompt, type
netscreen.