Juniper MX480, Руководство по оборудованию

Страница: 215 / 420

NOTE: The circuit breaker may bounce back to the off ( O ) position if you
move the breaker too quickly.
Observe the status LEDs on the power supply faceplate. If the power supply is correctly
installed and functioning normally, the
PWR OK
,
BRKR ON
, and
INPUT OK
LEDs light
green steadily.
Connecting the MX480 to the Network
• Tools and Parts Required for MX480 Router Connections on page 215
• Connecting the MX480 Router to a Network for Out-of-Band Management on page 215
•
Connecting the MX480 Router to a Management Console or Auxiliary Device on page 216
•
Connecting the MX480 Router to an External Alarm-Reporting Device on page 217
• Connecting DPC, MPC, MIC, or PIC Cables to the MX480 Router on page 218
• Connecting the Alarm Relay Wires to the MX480 Craft Interface on page 219
Tools and Parts Required for MX480 Router Connections
To connect the router to management devices and line cards, you need the following
tools and parts:
•
Phillips (+) screwdrivers, numbers 1 and 2
•
2.5-mm flat-blade (–) screwdriver
• 2.5-mm Phillips (+) screwdriver
• Wire cutters
•
Electrostatic discharge (ESD) grounding wrist strap
Connecting the MX480 Router to a Network for Out-of-Band Management
To connect the Routing Engine to a network for out-of-band management, connect an
Ethernet cable with RJ-45 connectors to the
ETHERNET port on the Routing Engine. One
Ethernet cable is provided with the router. To connect to the ETHERNET port on the
Routing Engine:
1.
Turn off the power to the management device.
2.
Plug one end of the Ethernet cable ( Figure 75 on page 216 shows the connector) into
the
ETHERNET
port on the Routing Engine. Figure 74 on page 216 shows the port.
3.
Plug the other end of the cable into the network device.
215 Copyright © 2019, Juniper Networks, Inc.
Chapter 3: Initial Installation and Configuration