Juniper MX480, Руководство по оборудованию

Страница: 216 / 420

Figure 74: Ethernet Port
Figure 75: Routing Engine Ethernet Cable Connector
Connecting the MX480 Router to a Management Console or Auxiliary Device
To use a system console to configure and manage the Routing Engine, connect it to the
appropriate
CONSOLE port on the Routing Engine. To use a laptop, modem, or other
auxiliary device, connect it to the AUX port on the Routing Engine. Both ports accept a
cable with an RJ-45 connector. One serial cable with an RJ-45 connector and a DB-9
connector is provided with the router. To connect a device to the
CONSOLE
port and
another device to the
AUX
port, you must supply an additional cable.
To connect a management console or auxiliary device:
1.
Turn off the power to the console or auxiliary device.
2.
Plug the RJ-45 end of the serial cable ( Figure 77 on page 217 shows the connector)
into the
AUX
port or
CONSOLE
port on the Routing Engine. Figure 76 on page 217 shows
the ports.
3.
Plug the female DB-9 end into the device's serial port.
NOTE:
For console devices, configure the serial port to the following values:
• Baud rate—9600
•
Parity—N
•
Data bits—8
• Stop bits—1
• Flow control—none
Copyright © 2019, Juniper Networks, Inc. 216
MX480 Universal Routing Platform Hardware Guide