Juniper Junos Space JA1500, Руководство по оборудованию

Страница: 62 / 210

2.
Power on the appliance by toggling the power switch located at the rear panel of the
appliance.
The appliance is shipped with a version of the Junos Space Network Management
Platform software installed. When the appliance is powered on, the serial console
displays diagnostic information before booting. When booting is complete, the serial
console displays the login prompt. You are now ready to configure basic settings on
the appliance.
Related
Documentation
Connecting a Junos Space Appliance to a Management Console on page 43
•
•
Configuring a Junos Space Appliance as a Junos Space Node on page 48
•
Configuring a Junos Space Appliance as a Standalone or Primary FMPM Node on
page 70
•
Installing a Junos Space Image on a Junos Space Appliance by Using a USB Drive on
page 96
•
Powering Off the Junos Space Appliance on page 102
Configuring a Junos Space Appliance as a Junos Space Node
You can configure a Junos Space Appliance as a Junos Space node or as a specialized
node used for fault monitoring and performance monitoring (FMPM). To configure a
Junos Space Appliance as a Junos Space node, you must configure basic network and
system settings to make the appliance accessible on the network.
NOTE:
•
From Junos Space Network Management Platform Release 14.1R2 onward,
you can configure Junos Space Ethernet interfaces with only IPv4 addresses,
or both IPv4 and IPv6 addresses.
•
From Junos Space Network Management Platform Release 16.1R1 onward,
you can configure access to Junos Space through a Network Address
Translation (NAT) gateway.
The disk space allocation for a JA2500 Junos Space Appliances is as follows:
• 1.2 TB for /var
• 715 GB for /var/log
• 92 GB for /tmp
• 92 GB for /
Before you begin, do the following:
• Ensure that the Junos Space Appliance is connected to a management console and
that the management device is powered on.
Copyright © 2018, Juniper Networks, Inc. 48
JA2500 Junos Space Appliance Hardware Guide