Juniper JRR200, Руководство по оборудованию

Страница: 37 / 108

Console Port Connector Pinout Information for the JRR200 Route Reflector
The console port is an RS-232 serial interface that uses an RJ-45 connector to connect
to a console management device. The default baud rate for the console port is 9600
baud.
Table 21 on page 37 provides the pinout information for the RJ-45 console connector. An
Ethernet cable that has an RJ-45 connector at either end and an RJ-45 to DB-9 serial
port adapter are supplied with the route reflector.
Table 21: Console Port Connector Pinout Information
Description Signal Pin
Request to Send RTS 1
Data Terminal Ready DTR 2
Transmit Data TXD 3
Signal Ground Ground 4
Signal Ground Ground 5
Receive Data RXD 6
Data Set Ready DSR/DCD 7
Clear to Send CTS 8
37 Copyright © 2018, Juniper Networks, Inc.
Chapter 2: Site Planning, Preparation, and Specifications