•
RJ-45 to DB-9 serial port adapter (provided)
•
Management host, such as a PC, with an Ethernet port (not provided)
Install the Mounting Shelf in a Rack
The following table specifies the holes in which you insert cage nuts and screws to install the mounting hardware required
(an x indicates a mounting hole location). The hole distances are relative to one of the standard U divisions on the rack.
The bottom of all mounting shelves is at 0.02 in. (0.05 cm) above a U division.
Mounting Shelf
Distance Above U Division
Holes
X
2.00 in. (5.1 cm) 1.14 U
4
X
1.51 in. (3.8 cm) 0.86 U
3
X
0.88 in. (2.2 cm) 0.50 U
2
X
0.25 in. (0.6 cm) 0.14 U
1
1. If needed, install cage nuts in the holes as specified in the table.
2. On the back of each rack rail, partially insert a mounting screw into the lowest hole specified in the table.
3. Install the mounting shelf on the back of the rack rails. Rest the bottom slot of each flange on a mounting screw.
4. Insert screws into the open holes in each flange of the mounting shelf.
5. Tighten all the screws completely.
2