Juniper CTP151 Platform, Руководство по оборудованию, Страница: 83 / 104

9. After the system reboots, go back to the BIOS menu and change the first boot device to the one that
includes “UEFI OS (P5: SFSA20...”.
10. Save the configuration and exit the BIOS menu.
RELATED DOCUMENTATION
Powering On the CTP151 Device | 75
Configuring the First Boot Script for the CTP151 Device | 77
Powering Off the CTP151 Device | 80
Configuring the First Boot Script for the CTP151 Device
For the first-time boot process, there is a series of login prompts that require the following settings:
• You must provide a password for the root account. The ctp and ctp_cmd accounts have default
passwords. The default password for the ctp user account is "ctp", and the default password for the
ctp_cmd user account is "ctp_cmd". You can change the default passwords later.
• Supported protocol or protocols—(0) IPv4 only, (1) IPv6 only, or (2) IPv4 and IPv6. Enter the appropriate
number value.
• Default interface—From the list of available devices, such as eth0 and eth1 (or more), enter the name
of the interface that you want to set as the default.
• Hostname of the device.
• IP address of the interface—Enter the IP address of the selected interface, or accept the loopback
address (127.0.0.1) as the default.
• Netmask of the IP address—Enter the netmask (such as 255.255.255.128), or accept 255.255.255.0
as the default.
• Gateway IP address—Enter the IP address of the gateway, or accept the local address (127.0.0.1) as
the default.
• Maximum transmission unit (MTU)—Enter the MTU in bytes, or accept 1500 bytes as the default.
77