Juniper CTP1000 Series, Руководство по оборудованию

Страница: 67 / 88

CHAPTER 12
Accessing the CTP1000 Platform
• Setting Up Management Access on the CTP1000 Platform on page 57
• CTP1000 Console Port Setup on page 57
•
Using HyperTerminal with the CTP1000 Platform on page 58
•
Connecting Directly to the CTP1000 Platform on page 58
• CTP1000 Platform SSH Setup on page 59
Setting Up Management Access on the CTP1000 Platform
Before you power on the device, you must set up a management console. You use the
console to communicate with the device during the power-on process, to set an IP
address, and to manage the system using the command-line interface (CLI).
You can monitor and manage the system through either of these methods:
• Console terminal—Connect a console (PC, Macintosh, or UNIX workstation) directly
to the device’s RS-232 serial port.
•
Remote console—Connect 10/100Base-T to an Ethernet port, and run SSH from a
remote console.
For initial access to the system, you need to physically connect your console directly to
the device’s RS-232 port. Through this connection you use the CLI to set an IP address
on the device. After you configure the IP address, you can access the device remotely
(for example, through SSH).
Related
Documentation
CTP1000 Console Port Setup on page 57
•
•
Using HyperTerminal with the CTP1000 Platform on page 58
•
Connecting Directly to the CTP1000 Platform on page 58
•
CTP1000 Platform SSH Setup on page 59
CTP1000 Console Port Setup
You can connect a console terminal (PC, Macintosh, or UNIX workstation) through the
RS-232 terminal port. When you connect a console directly to the device, you can configure
the device without an IP address.
57 Copyright © 2015, Juniper Networks, Inc.