3 | INSTALLATION
Repeater Operation Manual
Version 2.00
Model
: JL20
©
2008 Juni | America Inc
.
3.4 Inspection before Installing the Repeater
Check if there is any physical damage on the Repeater cabinet. If any damage is found, it
is advised to perform close inspection on the operating features and RF signal test to
verify Repeater performance.
Check if there are any loose RF cables inside and/or outside the Repeater.
Check if there’s any part of the cabinet exposed to water or other liquid substances.
Before installing the Repeater, check the serial number of the units to be installed.
Confirm the correct accessories have been supplied.
3.5 Installation Procedure
3.5.1 Repeater Cabinet Installation
The JL20 can be mounted on a wall or the ceiling. This section describes how the Repeater
can be mounted on three different surfaces – lumber, drywall (gypsum, plasterboard) and
concrete.
On all surfaces, the mounting is achieved by combining the two mounting brackets – one for
the Repeater (Bracket A) and one for the surface (Bracket B).
[Figure 8] Mounting Brackets A (shown on left) & B (shown on right)
