Jungheinrich EKE 30-2 ac, Руководство по эксплуатации

Страница: 17 / 49

1002
.GB
C 2
2 Commissioning
m
Operate the truck on battery power only! Rectified alternate current will damage the
electronic components. Cables connected to the battery (trailing cables) must be less
than 6 meters in length.
To make the truck operational after delivery or transport, perform the following steps:
– Install the battery if applicable; do not damage the battery cables.
– Recharge the battery (refer to chapter D).
– Remove the parking brake shipping restraint if applicable!
(see section 3).
– Commission the truck as stipulated.
(see chapter E).
3 Parking brake shipping restraint
f
The shipping restraint must be removed prior to commissioning the truck. The
shipping restraint locks the pressure spring acting on the parking brake, causing the
truck to be unbraked when it is deenergised.
The shipping restraint is inserted when the truck is delivered with an uncharged
battery.
The shipping restraint consists of a KL securing ring (3) fastened to a red cable strap
visibly protruding from the seat door. The KL securing ring is fitted on the solenoid
armature. This prevents the pressure spring from applying the brake.
Removing the shipping restraint:
– Connect a charged battery.
– Open the seat door.
(see chapter F).
– Pull the KL securing ring (3) with
the cable strap off the armature.
m
Never remove the second KL
securing ring present on the
armature during commissioning!
– Close and lock the seat door.
– Switch main switch and key
switch on again.
A
The truck is now ready for
operation.
3
1002
.GB
C 2
2 Commissioning
m
Operate the truck on battery power only! Rectified alternate current will damage the
electronic components. Cables connected to the battery (trailing cables) must be less
than 6 meters in length.
To make the truck operational after delivery or transport, perform the following steps:
– Install the battery if applicable; do not damage the battery cables.
– Recharge the battery (refer to chapter D).
– Remove the parking brake shipping restraint if applicable!
(see section 3).
– Commission the truck as stipulated.
(see chapter E).
3 Parking brake shipping restraint
f
The shipping restraint must be removed prior to commissioning the truck. The
shipping restraint locks the pressure spring acting on the parking brake, causing the
truck to be unbraked when it is deenergised.
The shipping restraint is inserted when the truck is delivered with an uncharged
battery.
The shipping restraint consists of a KL securing ring (3) fastened to a red cable strap
visibly protruding from the seat door. The KL securing ring is fitted on the solenoid
armature. This prevents the pressure spring from applying the brake.
Removing the shipping restraint:
– Connect a charged battery.
– Open the seat door.
(see chapter F).
– Pull the KL securing ring (3) with
the cable strap off the armature.
m
Never remove the second KL
securing ring present on the
armature during commissioning!
– Close and lock the seat door.
– Switch main switch and key
switch on again.
A
The truck is now ready for
operation.
3