Jungheinrich EJC 212-220, Руководство по эксплуатации

Страница: 29 / 93

0606
.GB
D 6
The flashing LED indicates the charge status or a fault (for flashing codes see “LED
Display” table).
Z
If the mains connector (5) is connected to the mains, all the truck’s electrical functions
will be interrupted (electrical start block). The truck cannot be operated.
– Remove the connector (5) from the socket and store it in the battery compartment.
Z
Charging continues automatically after a mains failure.
Charging can be interrupted by removing the mains connector and continued as
partial charging.
M
The mains cable must not be opened.
F
Before starting the truck, the battery panel must be firmly closed.
Charging times
The duration of charge depends on the battery capacity.
LED display
Compensation charge
Compensation charge starts automatically when charging is complete.
Partial charging
The charger is designed to automatically adapt to partially charged batteries. This
keeps battery wear to a minimum.
4.2 Charging the battery with a stationary charger (
o
)
– Park the truck securely (see Chapter E).
M
Only connect and disconnect the battery connector and the socket when the mains
and charger are switched off.
– Expose the battery (see Section 3).
LED green
(charge status)
LED red
(fault)
Display
Lit --- Charging complete, battery full. (Charging interval,
compensation charge)
Flashes slowly --- Charging
Rapid flash --- Display at beginning of charge or after setting a new
characteristic curve. Number of flash pulses
corresponds to the characteristic curve set.
--- Lit Overtemperature. Charging is interrupted.
--- Flashes slowly Safety charging time exceeded. Charging is
cancelled. Mains must be disconnected for charging
to
recommence.
--- Rapid flash Invalid characteristic curve setting.
--- --- Mains failure and/or no battery connected.
0606
.GB
D 6
The flashing LED indicates the charge status or a fault (for flashing codes see “LED
Display” table).
Z
If the mains connector (5) is connected to the mains, all the truck’s electrical functions
will be interrupted (electrical start block). The truck cannot be operated.
– Remove the connector (5) from the socket and store it in the battery compartment.
Z
Charging continues automatically after a mains failure.
Charging can be interrupted by removing the mains connector and continued as
partial charging.
M
The mains cable must not be opened.
F
Before starting the truck, the battery panel must be firmly closed.
Charging times
The duration of charge depends on the battery capacity.
LED display
Compensation charge
Compensation charge starts automatically when charging is complete.
Partial charging
The charger is designed to automatically adapt to partially charged batteries. This
keeps battery wear to a minimum.
4.2 Charging the battery with a stationary charger (
o
)
– Park the truck securely (see Chapter E).
M
Only connect and disconnect the battery connector and the socket when the mains
and charger are switched off.
– Expose the battery (see Section 3).
LED green
(charge status)
LED red
(fault)
Display
Lit --- Charging complete, battery full. (Charging interval,
compensation charge)
Flashes slowly --- Charging
Rapid flash --- Display at beginning of charge or after setting a new
characteristic curve. Number of flash pulses
corresponds to the characteristic curve set.
--- Lit Overtemperature. Charging is interrupted.
--- Flashes slowly Safety charging time exceeded. Charging is
cancelled. Mains must be disconnected for charging
to
recommence.
--- Rapid flash Invalid characteristic curve setting.
--- --- Mains failure and/or no battery connected.