19
2.2
Using the Display:
2.2.1 Activating the Module with the Default Code
Procedure
• Release the emergency disconnect switch.
• Enter the default code 1-2-3-4 using the soft keys below the display (3).
The module is enabled.
2.2.2 Blocking an Enabled Module
Procedure
• Press the key under the "Switch off" symbol (5) on the
display unit.5
The module is blocked.
As an option, the customer service department can pre-set the module such that the
module is blocked automatically after a defined delay at a standstill. Automatic
blocking does not occur if the module has been enabled by the set-up code or the
set-up transponder.
