Jünger Audio-Studiotechnik GmbH
page
15
Important note!
When you are selecting an external source for the MIX4
(see above) there are
two ways
to leave this mode (see 4.1 or 4.2 below) :
0
.
Turn source selection mode on by pressing the
<SRCE>
button.
1.
Select a Channel Strip
where you want to assign an external source to.
Press
a Channel Button - Channel Button is
blinking green.
2.
Search for an input
(tie line) that is connected to an external router destination port.
Turn
the Channel Rotary Knob until - Channel Button is
blinking green / yellow.
3.
Turn external control on
.
Press
that Channel Button - Channel Button is
blinking red/yellow
or
yellow
3.1
Select a source
if blinking yellow (Klotz Digital VADISII)
Turn
the Channel Rotary Knob to select a source
3.2.1 Select a Group
if blinking red/yellow (LAWO / Mandozzi / DHD)
Turn
the Channel Rotary Knob to select a group
3.2.2
Select a source
from a (pre selected) group.
Press
that Channel Button again - Channel Button is
blinking yellow
Turn
the Channel Rotary Knob until the router source name appears in the Channel
4.
Turn
source selection
mode off
.
4.1
Press
<SRCE>
button - Channel Button turns off
The
name
of the
external source
will stay in the Channel Display.
4.2
Press
that Channel Button - Channel Button turns
off
The
name
of the
local input
(i.e. the name of the tie line) will appear in the Channel Display
You
must
press <SRCE>
afterwards to leave source selection mode!