2. LOCATION OF PARTS AND CONTROLS
Some basic settings are to select by switches on the rear panel
or by switches and jumpers at the internal circuit boards of the
unit. These settings can occur general changes for operation
and should made by qualified engineering staff only.
Rear panel
Following switches in the REMOTE- field at rear panel are used
for configuration of the unit.
SDI Bypass
switches SDI bypass on/off (see also 3.10)
(only for SDI version!)
LOCAL
Setting of FRONT PANEL operation mode
EN
ABLE Unit can be controlled by front panel
and
by
serial remote interface.
DIS
ABLE Unit can be controlled only by using serial remote
interface. Front panel is locked.
Note: DISABLE is only activated if serial remote
control is connected!
ADDR
Selection of the device address for serial
remote, 16 device addresses selectable
Note: Within a line of remote controlled units every
device needs a different address! The selected
2.3
SWITCHES AND
JUMPERS FOR
CONFIGURATION
address is valid after next power-on reset of the unit.
Internal
To set any internal jumper or switches it is necessary to open
the unit.
PLEASE DO NOT MAKE ANY ALTERATIONS WITH THE
MAINS STILL CONNECTED TO THE UNIT!
Loosen the screws on the top cover and remove. Then you can
see all jumper and switches as shown in the drawing below.
After setting of jumper or switches reassemble the unit in
opposite order.
Operation manual b40, chapter 2 -control elements and displays- page 2-4