Mounting and connecting the device
Figure
3
: Mounting of the continuous controller module
(4) Supporting frame
(5) Frame
(6) Continuous controller module
(7) Fastening screws, plastic
(8) Buttons
(9) Connection terminal for extension module (optional)
(10) KNX device connection terminal
(11) Box screws
(14) Wall Box
o
Mount supporting frame (4) in the right orientation on an wall box. Note marking
TOP
. Use
only the enclosed box screws (11).
o
Push frame (5) onto supporting frame.
i
Use only cables which are approved for KNX.
o
Connect the continuous controller module (6) to the KNX using KNX connecting terminal
(10) and push onto the supporting frame.
o
Fasten the continuous controller module to supporting frame using the enclosed plastic
screws (7). Tighten the plastic screws only lightly.
o
Before mounting the buttons (8), load the physical address into the device.
5.2 Commissioning
Loading the physical address and application software
Project design and commissioning with ETS3.0f or more recent.
The device is connected and ready for operation.
4/6
Room temperature controller module 2-gang
32589705
J0082589705
28.06.2017
