JUNG Hebe- und Transporttechnik GmbH
JKB Operating Manual 02/2007
Page 2
OPERATING
MANUAL
Please read first before starting work
Revolving Transport Trolleys JKB
For safer lifting of loads we recommend hydraulic jacks by JUNG.
The weight of the loads may not exceed the load capacity of the
transport trolleys. If centre of gravity is outside the centre of load please
ensure that load weight does not exceed the load capacity of each
trolley cassette.
Each trolley should be fixed to the load when moving a load over an
uneven floor.
Please follow the sequences described below when loading / unloading.
LOADING
Lift up rear end of load and place two trolleys underneath.
If necessary lift up step by step alternately front and rear end.
Use squared timber to secure the load between the steps to avoid
big angle of the machine surface until you reach the height of the
cassettes.
Connect two side-by-side cassettes with a connecting rod for
affixed support on uneven surfaces.
Adjust connecting rod and clamp it if necessary!
Place the load slowly and carefully on the cassettes.
Attention! Load may tilt
Remove jacks.
Lift up front end of load and place one or two trolleys underneath.
When using three trolleys distribute the load cassettes in such a
way that the weight is evenly divided across all cassettes.
Attention! Take the
load’s centre of gravity into consideration!
Place the load slowly and carefully on the cassettes.
Remove jacks.
0,5
°
UNLOADING
(Reverse the loading steps)
Lift up the front end of the load and remove first the centre placed cassette.
Lower the front end of the load slowly and carefully to the ground or to a
suitable base. Lift up rear end of the load and remove connected cassettes.
Lower the rear end of the load slowly and carefully to the ground or to a
suitable base.
Lower the load step by step to the floor.
TRANSPORT
Ensure that the ground intended for transport is clean and free of any loose
objects. Move the load by pushing manually or using a suitable towing vehicle.
Ensure that the cassettes are always securely positioned whilst moving.
Revolving transport trolleys do not have any in-built braking
system:
Never exceed 1 mph when moving!
Do not move on a slope of more than 0.5 degree.
Only use suitable towing vehicles.
Make sure that the load does not exceed the permissible towing
weight.
Always use the connection bar delivered with the rear cassettes.
This ensures that the cassettes run parallel under the weight as long
as the surface is hard, even and clean.
On surfaces that are not perfectly smooth, level and clean ensure that
all trolleys are affixed to the load in a suitable manner.
