Radio hand-held transmitter
Figure 2: LED function
Phase 1: Actuation/sending display (red) or low battery level (flashing)
Phase 2: Actuator feedback (red/green) or sending error (flashing)
5
Commissioning
Inserting the battery
The battery is included.
Obey the battery safety instructions.
￭
Unscrew the battery compartment on the back of the hand-held transmitter.
￭
Keep contacts of batteries and device free of grease.
￭
Apply battery to the positive contact of the battery holder. Observe polarity: the positive
pole of the battery must be at the top.
￭
Press gently on battery to snap it in.
￭
Close and screw the battery compartment.
Hand-held transmitter is ready for operation.
Load the address and the application software
Project design and commissioning with ETS5 or more recent.
If the device does not contain any application software, or the wrong application software,
then the Status LED (1) flashes slowly in red and green for 3 seconds after a button-
press.
The Prog (Figure 3) button can be pressed with a thin wire or paper clip through the hole in the
battery cover.
Figure 3: Button Prog
￭
Press the Prog button.
The Status LED (1) flashes red.
￭
Load the physical address and domain address into the device.
The status LED goes out.
￭
Write the physical address and domain address on the inner side of the battery compart-
ment lid.
￭
Load the application software into the device.
3 / 5
82590833
15.07.2019
j0082590833
