Disconnect the connection between the Radio Management transmitter and the eNet
actuator
Figure 6: Disconnecting
o
Press the
Prog
button (3) of the gateway for approx. 4 seconds.
The LED (2) of the gateway flashes slowly. The device is in programming mode for
approx. 1 minute.
o
Also switch all the eNet Bus actuators to be disconnected to programming mode (see
actuator instructions).
o
Press the channel button on the Radio Management transmitter for longer than one second
or the scene button for longer than three seconds.
The gateway detects that the actuator was previously connected and instigates the
disconnection operation.
The eNet actuator is disconnected. The actuator exits programming mode automatically.
Resetting the device to the factory setting
All the connections in the gateway between transmitters and actuators are disconnected.
Recommissioning must take place.
i
Before resetting to the factory setting, disconnect connected Radio Management actuators
(see Disconnecting the connection to the Radio Management actuator). This ensures that
setting up new connections does not cause unintentional switching operations.
o
Press the
Prog
button for at least 20 seconds.
The status LED flashes after 4 seconds. After 20 seconds the status LED flashes faster.
o
Release the
Prog
button and press it once again within 10 seconds.
All the connections are disconnected. The status LED flashes more slowly for approx. 5
seconds.
5 Appendix
The icon confirms the conformity of the product to the relevant guidelines.
5.1 Technical data
Rated voltage
AC 230 V ~
Mains frequency
50 / 60 Hz
Rated load current
16 A (I
L
)
Power consumption
max. 1 W
Degree of protection
IP 20
6/8
82582113
J:0082582113
13.03.2014
eNet
Radio converter in SCHUKO housing
