When teaching a transmitter, the range of the receiver is reduced to about 5 m. The distance
between the receiver and the transmitter being taught should therefore be between 0.5 m and
5 m.
The function switch for the channel being taught is set to
ON
.
o
Switch radio receiver to programming mode (see instructions for receiver).
o
Press the "+" or "-" button of the desired channel longer than 1 second.
o
Exit programming mode of the receiver (see instructions for the receiver).
The channel of the transmitter has now been taught in the radio receiver.
Teaching a light scene button
The function switch for button being taught is set to
OFF
.
o
Switch receiver to programming mode (see instructions for receiver).
o
Press the light scene button for longer than 3 seconds.
o
Exit programming mode of the receiver (see instructions for the receiver).
Light scene button has been taught.
Deleting All Off
If a certain receiver should not respond to the All Off button, then this function has to be
deleted.
o
Switch receiver to programming mode (see instructions for receiver).
o
Press All Off button
1-
for longer than 10 seconds.
Function has been deleted.
o
Exit programming mode of the receiver (see instructions for the receiver).
6 Appendix
Remove empty batteries immediately and dispose of in an environmentally friendly
manner. Do not throw batteries into household waste. Consult your local authorities
about environmentally friendly disposal. According to statutory provisions, the end
consumer is obligated to return used batteries.
6.1 Technical data
Rated voltage
DC 6 V
Battery type
2×lithium CR 2016
Ambient temperature
0 ... +55 °C
Relative humidity
max. 75 % (No moisture condensation)
Protection rating
IP 20
carrier frequency
433.42 MHz (ASK)
Transmitting range in free field
typical 30 m
Transmitting power
< 10 mW
6.2 Troubleshooting
After a brief button-press the LEDs flash five times.
Cause: battery in the wall transmitter is almost empty.
Change battery (see section changing the battery).
Receiver does not respond, or only sometimes.
Cause 1: Radio range exceeded. Structural obstacles reduce the range.
Using a radio repeater.
Cause 2: function switches are in the wrong position.
Check positions of function switches.
7/8
32532713
J:0082532713
09.12.2010
Radio Management
Flat wall-mounted radio transmitter
