First the old light scene is called up; do not release the button during this. After about
3 seconds the new light scene is saved and activated.
i
If during saving of a light scene the blind is not in an end position, or is on the way there,
then that blind is not integrated into the light scene.
Call up All Off
In the teaching procedure for a channel button or a light scene button, the All Off button of the
receiver is automatically also taught, with the exception of radio blind actuators.
Function switch 1 is in the
OFF
position (see Commissioning chapter).
o
Press button
1-
longer than 1 second.
The loads at all taught receivers are switched off.
5 Information for electrically skilled persons
5.1 Fitting and electrical connection
Connecting and fitting the device
Maintain a distance of at least 1 m between transmitter and receiver.
Maintain distance to large metal surfaces, e.g. metallic door frames.
i
Perform commissioning and teaching procedures before installation (see chapter
Commissioning).
o
Carefully remove inscription panel cover (5) and inscription panel (4) from the wall
transmitter (figure 1).
o
Slacken fastening screws (3).
o
Remove wall transmitter (1) from the base plate (2).
o
Inset battery if necessary (see section Changing the battery).
o
If necessary, set functions using function switch (see Commissioning chapter).
o
Glue or screw the base plate to an even surface (information on gluing mounting). The
TOP/OBEN
label has to be at the top.
o
Screw wall transmitter onto base plate.
o
Attach covers with labelling fields.
Information on gluing mounting
To be able to fasten the wall transmitter safely, the substrate must be flat and free of dust and
grease.
o
Remove the rear, unpunched film of the enclosed adhesive pad.
o
Align the adhesive pad, stick it to the surface and smooth it out. Remove air bubbles.
o
Remove the two inner segments of the front film.
o
Align the base plate to the external punching and stick it on.
i
In the case of multiple combinations, the abutting sides of the adhesive pads must be cut
along the external punching using a ruler and a cutter (figure 4).
4/8
32532713
J:0082532713
09.12.2010
Radio Management
Flat wall-mounted radio transmitter
