There could be an increased likelihood of unsuitable combinations of LED lamp and
switch insert.
Lit push-buttons must have a separate N terminal.
Image 2: Clampable conductor cross-section
The load can be switched by briefly pressing the Test button.
Connecting and mounting the device as a room thermostat (see figure 3)
Recommended installation height: 1.50 m.
Image 3: Connection diagram in combination with a room thermostat cover and KNX
RF push-button
(6)
Switching contact for switching to cooling mode
(7)
Electrothermal valve drive
If 230 V is applied to extension input 1, cooling mode is active.
Resetting the overheating protection / short-circuit protection
If the electronic overheating or short-circuit protection has been activated, separate
the switch insert from the grid for a few minutes.
Electronic switch insert 1-channel
6 / 11
82400533
25.08.2022
J0082400533
