Jumper JPD-ES200, Инструкция по эксплуатации

Страница: 10 / 80

Troubleshooting
Fault
phenomenon Probable causes Troubleshooting procedures
Unable to boot Severe electricity shortage ● Replace the battery
Sense of
piercing
pain during
The electrode pad is not
stuck tightly ● Stick electrode pad again
● Replace electrode pad
Fall-off
of
electrode
● Sweat on skin
● Ineffective
stickiness of
electrode pad
● Wipe the sweat on skin
and re-attach the
electrode pad
Inconsistent
strength
between
Disconnected main unit,
electrode wires and electrode
pads
● Make sure the
connection among main
unit, electrode
Power
failure
● Electricity shortage
● Replace the battery
before using it
Sudden alarm
pause
treatment in
Fall-off of electrode pad
Re-attach the electrode
pads on the treatment sites
Working conditions
Ambient temperature: 5-40 ℃ ; relative humidity: ≤ 80%
Storage conditions
Ambient temperature: -40 ℃～ 55 ℃ ; relative humidity: 10%~93%
Technical parameters:
1. Operating voltage: 6V DC
2. Working mode: continuous operation
3. Maximum output pulse energy: for 500 Ω of load resistance, the energy
value
≤ 300mj
4.
Pulse width: 0.150-0.200ms
，
error
± 30% 5.Pulse frequency: 1-120Hz ， error
±
30% 6.Rated load resistance: 500
Ω
7. Maximum output voltage peak in open circuit:
≤
500V
8.Setting range of treatment intensity: 0-60; adjustable interval: 1
9.Dimensions (L*W*H) of main unit: 121.8 mm *63.6 mm *22.2 mm
10.Electrode pad dimension: 50mm*50mm
11.Main unit weight: 86g (excluding battery)