JUMO Quantrol LC100, Руководство по эксплуатации

Страница: 13 / 40

13
3 Operation - Configuration - Parameterization
3.1 Operation
3.1.1 Display and operating elements
3.1.2 Self-optimization, setpoint and manual mode
On the basis of the Normal display , the following Functions are available:
3.1.3 Ramp function/firing curve
(A) Programming / one level deeper
(B) Value reduction / previous parameter
(C) Value increase / next parameter
(D) Function key / leave level
(E) Red 7-segment display (factory-set: Actual
value); 4-digit, configurable decimal place (auto-
matic adjustment in the case of display overflow)
(F) Green 7-segment display (factory-set: Setpoint);
4-digit, configurable decimal place; also display
of level and parameter symbols
The software version is displayed on
the device when simultaneously pres-
sing keys (A) and (C). (G) LED 1 to 3(5): Switching position of binary output
(LED is lit = output active)
(H) LED ramp function or firing curve
Start of self-optimization: Simultane-
ously press keys (B) and (C) (> 2 s)
"tUnE“ flashes in the lower display.
Abort of self-optimization: Simulta-
neously press keys (B) and (C)
No parameters are changed by the abort.
Change setpoint using keys (B) and
(C)
The longer the key is kept pressed, the faster the set
point value changes. The value will be automatically
applied.
Function key (D) (> 2 s) is used to
Change-over to manual mode and to
exit the manual mode
The output level (%) is displayed in the lower display
and can be changed with the keys (B) and (C).
(The controller automatically changes to manual mode
in the event of overrange/underrange and probe
break.)
Ramp function (start after mains ON or with
the binary function)
Firing curve (start with the binary function or
using the function key)
t1:
t2:
Start (actual
value)
Setpoint setting
was reached
t1:
t2:
t3:
t4:
Start
SP1 -> SP2
(automatically)
Timer start
Timer end
LED (H): Is lit with the ramp function active LED (H): Flashes in phase 1 (t1 to t2), is lit in
phases 2 and 3 (t2 to t4)
OFF
(F): Firing curve not active
(H)
(G)
(E)
(F)
(A) (B) (C) (D)
t
w/x
t1
rASL
t2
SP1
t
w
SP2
SP1
w/x
rASL
x
t1
t2 t3 t4
t1