JUMO exTHERM-DR, Руководство по эксплуатации

Страница: 83 / 100

13 Error messages
83
Diagnosis function
FLASH defective
1
Internal An error was detected during the cyclic memory test of the ROM.
RAM defective
1
Internal An error was detected during the cyclic memory test of the RAM.
CRC config.
1
Internal An error was detected by the checksum test (CRC16) in the configuration of
the diagnosis function.
CRC calib.
1
Internal An error was detected by the checksum test (CRC16) in the calibration data
of the diagnosis function.
Configuration Internal The configuration contains invalid data.
SW version
1
Internal The software versions are invalid.
Editing Internal An error has occurred during editing.
V too low Internal The internal voltage supply value has fallen below the permitted range.
V too high Internal The permitted range of the internal voltage supply has been exceeded.
Int. communic.
1
Internal An error has occurred during internal communication.
Switching cycles Internal The configured limit of the switching cycles of relay output controller K1 has
been exceeded.
The error can be remedied by reducing the current counter or increasing the
limit.
(So that the switching cycles are not accidentally set to 0 in the event of fur-
ther errors).
USB communic. Internal An error has occurred during USB communication.
Error display (Err) Origin Cause/remedy