JUMO DICON 400, Описание интерфейса

Страница: 34 / 44

5 Address tables
34
v
Chapter 6 “Sample program”
5.20 Commands
0x1236 FLOAT R/W Minimum (lower) limit of the tolerance band
0x1238 FLOAT R/W Maximum (upper) limit of the tolerance band
0x123A LONG R/W Segment time
0x123C INT R/W Repeat cycles (0 = no repeat; -1= repeats indefinitely)
0x123D INT R/W Target segment (only for repeat cycles
≠
0)
0x123E INT R/W Parameter set number (0 = Parameter set 1)
Address Data type/
bit number Access Signal designation
0x123F INT R/W Command value 1
Bit 0 —1 R/W not used
Bit 2 R/W Ramp/program stop
Bit 3 R/W Cancel program
Bit 4 R/W Operating mode
Manual
Bit 5 R/W Program start (without data)
Bit 6 R/W Change segment
Bit 7 —8 R/W not used
Bit 9 R/W Limit comparator acknowledgement
Bit 10 R/W Manual operation
Bit 11 R/W Automatic operation
Bit 12 R/W Activate Inhibit manual operation
Bit 13 R/W Deactivate operating mode Manual or Automatic-manual
Bit 14 R/W Start self-optimisation
Bit 15 R/W Cancel self-optimisation
0x1240 INT R/W Command value 2
Bit 0 —14 R/W not used
Bit 15 R/W Fast-forward
0x1241 INT R/W Command value 3
0x1242 LONG R/W Commands for text display
Bit 0 —7 R/W Logic input 1 — 8
Bit 8 + 9 R/W Logic 1 + 2
Bit 10 — 15 R/W not used
Bit 16 — 23 R/W Limit comparator 1 — 8
Bit 24 — 31 R/W Operating contact 1 — 8
0x1244 INT R/W Setpoint switching
-1 = no setpoint switching
0 — 3 = W1 — W4
0x1245 INT R/W Parameter set switching
-1 = no parameter set switching
0 = P1
1 = P2
Address Data type/
bit number Access Signal designation