5
WARNING
• When you dispose of your old refrigerators
and freezers, remove any doors. Children can
suffocate if they get trapped inside.
• This appliance contains insulation formed with
flammable blowing gases. Avoid safety hazards
by carefully disposing of this appliance.
• The appliance must be plugged into its own
dedicated 220-240V, 50Hz AC electrical outlet.
• Ensure that the electric outlet is properly
earthed to ground. Consult a qualified
electrician if you are unsure.
• Do not use an extension cord or adaptor plug.
• Unplug the appliance before cleaning.
• Never unplug the appliance by pulling on the
power cord. Always grip the plug firmly, and
pull straight out of the receptacle to prevent
damaging the
power cord.
• Chose a location that is not too cold - the
temperature should be above 10°C.
• Chose a location that is not affected by direct
sunlight.
Protection from Moisture
Avoiding placing the refrigerator in a place where
heavy moisture is present so as to minimise
possibility of rusting of metal parts. The refrigerator
should be kept out of water or direct sprayed water,
failure to do this could cause poor performance and/
or an electrical short could occur.
Protection from Heat
The refrigerator should be protected from excessive
heat sources and out of direct sunlight.
Moving
When fixed or moved, the refrigerator cannot be
set horizontally or reclined to more than 45° or
positioned upside down.
Never move while refrigerator is plugged in and
operating.
Once you have moved the refrigerator, leave
standing in a level position for 4 - 6 hours so that
the gas can settle.
• Put the appliance in a dry place, avoiding areas
of high moisture or humidity.
• Don’t put the appliance in direct sunlight.
• Don’t put the appliance near stoves, fires or
heaters.
• The appliance shall not be exposed to rain.
• Keep ventilation openings, in the appliance
enclosure or in the built-in structure, clear of
obstruction. Do not use mechanical devices
or other means to accelerate the defrosting
process.
Do not use electrical appliance inside the food
storage compartments of the appliance.
• If power cord is damaged, it must be replaced
by the manufacturer or its service agent or a
similarly qualified person in order to avoid a
hazard.
• The electrical system of this refrigerator must
be connected with an automatic 30mA circuit
breaker and/or residual current device (RCD).
If uncertain have a qualified electrician check
your electrical system before installation and/
or use.
Positioning
Ensure the sides and top have at least 50mm
clearance and the rear at least 100mm clearance to
ensure adequate ventilation.
Never cover the bottom front grill as this is required
for ventilation.
After installation the appliance should be left for
4 - 6 hours before it is switched on in order to allow
the refrigerant to settle.
Disposal of Old Appliances
The majority of components are recyclable, however
there are also dangerous chemicals inside. To
dispose of old fridges remove the doors and contact
your local council for recycling options.
Electrical Installation
The electrical system of this refrigerator must be
connected with an automatic 30mA circuit breaker
and/or residual current device (RCD). If uncertain
have a qualified electrician check your electrical
system before installation and/or use
