Jumbuck Paramount Multi Function
Spit Rotisserie (GEN-FP001) 0094874
IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT: READ THE ASSEMBLY INSTRUCTIONS IN THIS
BOOKLET BEFORE REMOVING THE CONTENTS OF
THIS CARTON
IMPORTANT SAFETY INSTRUCTIONS
DO NOT OPERATE THIS APPLIANCE BEFORE
READING THE INSTRUCTION
BOOKLET
DO NOT PLACE ARTICLES ON OR AGAINST
THIS APPLIANCE
DO NOT STORE CHEMICALS OR FLAMMABLE
MATERIALS OR SPRAY AEROSOLS
NEAR THIS APPLIANCE
DO NOT OPERATE THIS APPLIANCE
INDOORS
DO NOT ENCLOSE THIS APPLIANCE
DO NOT
LIGHT OR OPERATE WITH THE COVER
ON (COVER NOT INCLUDED)
For outdoor use only.
Improper installation, adjustment, alteration, service or maintenance can
cause property damage, injury or death.
Read the installation instructions thoroughly before installing this equipment.
Warning: accessible parts may be very hot. Keep young children away.
Do not move the appliance during use.
Any modification of the appliance may be dangerous and will void the
warranty.
Installer to leave instructions with the consumer and consumer to retain them
for future reference.
Please ensure all packaging and transit protection materials are removed prior
to using the fire pit.
This appliance must only be used in an above
ground open-air situation with natural
ventilation, without stagnant areas, where
products of combustion are rapidly dispersed
by wind and natural convection
This spit rotisserie is an outdoor appliance
only. Under no circumstances should it be
use indoors.
Do not store chemicals or flammable
materials near this appliance.
Unsupervised children should not be near
the spit rotisserie while in use or during
warm up or cool down.
People with flammable clothing such as
nylon etc. should keep well away from the
spit rotisserie when it is operating.
Do not leave solid fuel unattended on the
spit rotisserie.
Particular care must be taken when removing
the ash OR used fuel. Hot ash can cause
serious injury.
FOR
OUTDOOR
USE ONLY
Содержание GEN-FP001
Страница 1: ......
Страница 4: ...EXPLODED VIEW...
Страница 13: ...STEP 8 Install the motor part 1 onto the rear panel part 3 as per illustration below...