DISPLAY/CONFIG
This multi-function button is normally used to control the transceiver’s display. In the receive
mode the normal display has the S-meter, either as a numeric or graphic indication at the top
left of the screen, followed by the mode indicator, (LSB/USB/CW/Tune), and the receiver’s
filter, Wide (WID), Medium (MID), or Narrow (NAR).
A brief push of the DISPLAY/CONFIG button will over-write the mode and bandwidth with
the PWR display, which is only active during either transmit or tune operations. The next
brief push will display the SWR, again only active during transmit or tune. The third push
will show the current DC input voltage, the next push the transmitter’s final amplifier’s drain
current, also only active in transmit, and finally back to the normal display.
If the button is pressed and held, after a short delay you will be presented with the User
Configuration menu. This is more fully covered in the User Configuration section. To exit
from this menu, press and hold the button until a long beep is heard, then release.
AF GAIN
This is the normal volume control.
MODE
This multi-function button has four functions:
Mode Selection
The primary function is that of selecting the operating mode. A brief push will select in turn
LSB, USB, CW, or the Tune function.
Memory Copy
This function allows you to copy the contents of any active VFO to the User VFO Memory
bank.
To access this function, press and hold the MODE button until you hear a long beep. The
display will alter as shown above. To copy from the active VFO to a memory, rotate the VFO
knob clockwise, the direction arrow will point right, and the right-hand VFO memory
designator will increment. In the example above, the active VFO is A, whose frequency and
mode is displayed on the lower line, and is being copied to VFO memory P.
Copy VFO-A to VFO-P
Copy VFO memory J to active VFOA
3
