Jula Meec TOOLS 002781, Руководство по эксплуатации

Страница: 38 / 147

EN
37
Overload protection
The snowblower has an overload protection,
which switches it off when overloaded. Press
the reset button to start the snowblower again.
FIG. 6
MAINTENANCE
WARNING!
Before checking, cleaning and maintaining
the snowblower it must be switched off and
unplugged from the mains. Wait until the
rotor has come to a complete standstill.
• Prevent mechanical problems by properly
maintaining the snowblower before,
during and after each season.
• The rubber pads on the rotor that throw
up the snow are wearing parts and must
be regularly checked.
• Check the shear pins and bolts to ensure
that the machine is safe to use.
• Always follow the instructions when
putting the snowblower into storage.
• Allow the snowblower to run for a few
minute after clearing the snow so that the
moving parts do not freeze up.
Storage
At the end of the winter season the
snowblower should be put away in a safe
place:
– Out of the reach of children.
– Where the temperature and
humidity do not fluctuate too often
or too much.
– Where the snowblower is not
exposed to direct sunlight.
– Protected from rain and mist.
– On a level and stable surface.
– Do not store the snowblower
outdoors.
Folding the top handle
1. Release the clamp levers one the swivel
joint (one on each side of the handle).
2. The top handle can then be folded
forward or back, depending on how the
snowblower is to be stored.
FIG. 7
WARNING!
Check that the clamp levers are closed before
using the snowblower. Check that there is no
play between both halves of the handle.
If the snowblower needs repairing
Do not repair the snowblower yourself. Contact
an authorised service centre if there is a fault
on the snowblower. The snowblower must only
be repaired by an authorised technician.