ENGLISH
37
Starting
MAINTENANCE
Carry out the following measures before performing maintenance.
x
Before performing maintenance work on the appliance, disconnect the power cord and the water
supply.
x
Clean the water filter regularly. Remove the filter with a small pair of pliers and rinse it under
running water.
x
Clean the spray head under running water and clean the nozzle if necessary with the supplied
cleaning needle. Keep the appliance clean so that the cooling air can circulate freely.
x
Only use original spare parts from the supplier for repairs. If the machine is to be stored where
there is a risk of frost, or if it is to be stored for more than 3 months, antifreeze (as used in cars)
must be drawn into the appliance.
x
After start-up, there may be minor leakage from the pump, which will cease after a couple of hours.
Approx. 10 drips per minute is normal. If the leakage is greater than this, contact the supplier.
x
The electric motor is fitted with overcurrent protection. If this has been tripped, wait for 5-10
minutes before restarting the appliance. If the problem persists, see the troubleshooting chart or
contact your supplier.
x
When filling the pump with oil, use mineral oil SAE 20W40. Volume: 110 g.
x
Check the fuel filter regularly (1 in the figure below). Replace the filter if it is damaged or dirty.
x
Replace the fuel line if it is damaged.
