Jula 380-036, Руководство по эксплуатации

Страница: 30 / 38

ENGLISH
30

Make sure that everyone who works with this machine reads these safety instructions.
IMPORTANT! Hand and fingers may be injured on the rotating blade.

The machine has a safety circuit-breaker that prevents it from starting up again after a power
failure.

Before you use the machine, check that the voltage specified on the rating plate is the same as the
mains voltage in the workplace.

Check that the cross-section of the extension cord's conductors is sufficient for the saw's power
supply. The cross-section of the extension cord’s conductors should be at least 1.5 mm² (min. 2.5
mm² if the cord is longer than 20 m).

If you use a cable reel, the whole cable must be pulled out from the reel.

Check the power cord for damage. Do not use the appliance if the power cord is damaged.

Do not pull the power cord to disconnect the plug from the mains socket. Keep the power cord
away from heat, oil and sharp edges.

Do not leave the machine out in the rain or expose it to damp or wet conditions.

Make sure the work area is well lit.

Do not use near flammable liquids or gases.

Wear appropriate clothing. Loose-fitting clothing, jewellery and long hair can get caught in moving
parts.

Non-slip shoes are recommended when working outdoors.

Wear a hair net if you have long hair.

Do not overreach. Always maintain a firm footing and good balance.

The machine must not be used by persons under 16.

Keep children a safe distance from the machine when it is connected to the mains.

Keep the work area clean.

Cluttered work areas increase the risk of accidents and injuries.

Do not allow anyone to touch the machine or the power cord. Keep onlookers at a safe distance
from the work area.

You can easily lose control of the machine if you are distracted.

Note the direction of rotation of the motor and saw blade. Only use blades that are designed for the
maximum speed of the saw and the material to be cut.

Never attempt to slow the saw blade by applying pressure to its side.

Only use blades that are well sharpened and have no cracks or deformations.

Do not use high-speed steel blades.

Only use saw blades that are recommended by the manufacturer, comply with EN 847-1 and have
a warning label. The cutting width must be no smaller than and the basic thickness of the saw
blade must be no larger than the thickness of the splitter.

Damaged or faulty blades must be replaced immediately.

Never use blades which do not meet the data stated in these Operating Instructions.

Never dismantle the machine’s guards and safety devices or render them inoperative.

If the table insert is worn, replace it.

Always stand to the side of the blade when working with the saw.

Never load the machine so much that it cuts out.

Make sure that cut-offs do not catch on the saw blade. Risk of them being flung away with great
force.

Never attempt to remove loose splinters, chips or jammed pieces of wood when the blade is
rotating.

Always turn off the saw and unplug it before removing jammed pieces of wood or doing other
maintenance measures.

If the saw blade gap is worn, replace the table insert. Turn off the apparatus and unplug the power
cord before starting work.

Always switch off the appliance and unplug the power cord before making adjustments,
maintenance, measurements and cleaning.

Remove adjuster keys/spanners and other assembling tools before starting the machine.

Turn off the motor and unplug the power cord before leaving the work area.

Refit all guards and safety devices immediately after you have completed any repairs or
maintenance work.

Follow all safety instructions, maintenance instructions and other instructions, as well as technical
data.

Always follow the applicable rules regarding workplace safety and accident prevention.