Jula 242-160, Руководство по эксплуатации

Страница: 31 / 36

ENGLISH
31
OPERATION
Assembly
1. Turn the saw backwards to fold out the legs (fig. 1).
2. Loosen the lock knobs and fold out the legs (fig. 2 and 3). Tighten the lock knobs when the legs
have been extended. Set the saw table on the legs.
1 2 3
3. To use the saw as a bench ripsaw, press the lever (B) forwards (fig. 4). Turn the worktable around
until you hear a click. Before you do this, you may need to remove the screw clamps if previously
fitted.
4. Put the cross cut/mitre saw in the raised position so the position of the cleaver blade can be
adjusted. Do this by pulling out the latch (G). Loosen the wing nut (C) (fig. 5) holding the cleaver
blade.
5. Push in the lower blade guard latch (E) and lift up the guard (fig. 6). The movable blade guard must
be slid into the fixed blade guard so that the cleaver blade is positioned correctly.
4 5 6
6. Fit the cleaver blade (fig. 7). Make sure there is enough space between the cleaver blade and the
saw blade.
7. Screw in the screw (D) (fig. 8) to the stop, so that the saw is angled down.
8. Lock the saw in the lower position with the latch (G). Push in the lever (F) (fig. 9) and turn the
worktable around. It is locked in the correct position when you hear a click.
7 8 9
9. Fit the angle fence (D) and the parallel fence (E) (fig. 10). The saw can now be used as a bench
ripsaw.
10. To use the saw as a cross cut/mitre saw, press down the lever (F) (fig. 11) to release the
worktable. Turn the worktable around. It is in the correct position when you hear a click.
11. Pull out the latch (G) (fig. 12). Raise the saw. The saw table can now be placed in the vertical
position.