– 148 –
2) Adjustment procedure
1. Adjusting the position of the binder
Perform the adjustment of the position of binder
❾
with screws
.
2. Adjusting the open/close amount of the binder
Adjust the open/close amount of the binder with
collar
.
3. Adjusting the speed of open/close of the binder
The speed of open/close of binder
❾
can be
changed with speed controllers
and
.
When you desire to change the opening speed
of binder
❾
, loosen the nut of speed controller
located on the machine side and turn the
adjustment screw.
When you desire to change the closing speed of
binder
❾
, loosen the nut of speed controller
located on the operator side and turn the adjust-
ment screw.
After the adjustment, tighten nuts of speed con-
trollers
and
.
4. Adjusting the air regulator
(1) Insert the air hose to air regulator
.
(2) Use the air pressure at 0.4 to 0.5 MPa (4 to
5 kgf/cm
2
).
(3) Draw up knob
of regulator
, turn knob
and adjust the pointer to 0.4 to 0.5 MPa
to adjust the air pressure.
(4) After the adjustment, press downward knob
of regulator
.
(5) When drainage is collected at section
A
of
regulator
during using, press drain cock
to discharge the drainage.
❾
Air hose
A
WARNING :
As the work is performed while the power is ON, never touch the switches other than the necessary
one so as to prevent accidents caused by the malfunction of switches.
