ENGLISH
5
5 How to attach a tape reel
Use an "
Feeder setup stand for Electric feeder
" when attaching or replacing the tape reel.
（
1
）
To supply power
Connect a "connector for off-line setups" of the unit.
(2)
To set the tape reel (R lane)
Set the tape reel at the holder of the unit to feed the tape into
the tape feeder.
(3) To set a carrier tape and a cover tape
①
Open the upper cover to insert feed holes of the carrier tape
into the teeth of the sprocket wheel.
Moreover, pass the cover tape under the slit.
(4)
To set the cover tape
②
Pass the cover tape under the cover tape guide.
(5)
To set the cover tape
③
Lift the tension arm to pass the cover tape under the tension
roller.
(6)
To set the cover tape
④
Push the idler arm to insert the cover tape into the gap in the
space of gear by some 15 mm.
(7)
To set the tape reel (L lane)
Just as R lane, Set the tape reel at the reel support to feed the
tape into the tape feeder. (follow procedures 3 to 6)
(8)
To initialize the tape feeder
Initialize the tape feeder with the operation panel.
・
Press
■
and
▼
switches at the same time.
During initialization
After initialization
(9)
To check the supply position
Check to see if a component is located at the component
supply position. If it is not, perform the normal rotation pitch
feed operation with the operation panel.
(10)
To cut the remaining tape
Cut the end of tape protruding from the tape ejecting slot and
attach the tape to the mounter.
Guide 15 mm
Guide 3 mm
No good
Flashing
Lighting
