JUDO BIOSTAT 25 TGA
19
Maintenance
6.5
Replacing the batteries
When a change of batteries is necessary
(LED 4 flashes) the following procedure is
adopted:
–
Remove the panelling from the water
treatment device.
–
The battery is located behind the elec-
trical switch and must be disconnected
from the battery clip.
–
Exchange the battery and push it back
into the corresponding blank behind the
switch.
–
Remount the panelling on the water
treatment device.
–
Return run-down batteries to a distri-
butor or to a properly-authorised local
disposal return point.
6.6
Modifications / changes /
spare parts
ATTENTION
(see chapter “Safety information and
dangers due to non-compliance”)
Only original spare parts are to be used!
Independent modifications and changes are
prohibited for safety reasons! These can
impair the function of the water treatment
device, lead to lead and in extreme cases
can cause the water treatment device to
burst.
The test marks imprinted on the unit are only
valid if original spare parts are used.
Disconnect the power supply
from the socket.
Plug the power supply into the
socket!
Only use 9 V alkaline type block
batteries (see battery description).
