Blender with Glass Jug
Cautions
Before Use
•
Check that your mains power supply
corresponds to the voltage shown in this manual
(also shown on the rating plate, located under
the Motor Body ).
•
Do not connect the Plug into your socket
with wet hands.
•
Ensure that the Mains Lead is not near
any hot surface, and is not in a position on
the worktop where it could be ‘snagged’. The
Mains Lead should not hang over the side of the
worktop, where it could accidentally snagged
or pulled by children. There is a cord shortening
facility located under the Motor Body .
•
Do not move the appliance around by pulling
the Mains Lead .
•
Inspect the Glass Jug to ensure it is free from
chips or cracks - these could cause the Jug to
break during use causing injury.
•
Always keep the appliance out of the reach of
children.
•
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities or lack
of experience or knowledge, unless they have
been given supervision or instruction concerning
use of the appliance by a person responsible for
their safety.
•
This appliance is not intended to be operated
by means of an external timer or a separate
remote-control system.
•
The appliance should only be used as
instructed: there is potential for injury from
misuse.
•
Never mount the Jug Base /
Cutter Blade Assembly onto the Revolving
Spigot without the Jug attached.
•
Never leave the appliance unattended while it is
operating.
•
The Jug and Lid must be securely locked
in position before operating the machine: do
not attempt to defeat the safety interlock
mechanisms.
•
Do not use any other jug or parts other than
those supplied with the appliance.
In Use
•
Do not attempt to remove the Jug
or Lid while the machine is
working.
•
Do not operate the motor when
the Jug is empty.
After Use
•
Ensure the Cutter Blade Assembly
has come to a complete stop
before removing the Lid from
the Jug .
•
Always disconnect the electricity
supply before removing the Jug
from the Motor Body , or
approaching any part that moves
in use.
•
Do not use fingers to scrape
food away from the Cutter Blade
Assembly . A plastic scraper
may be used, but only when
the electricity supply has been
disconnected.
•
Care must be taken handling the
sharp blades when assembling,
emptying the Jug and during
cleaning.
•
Unplug the appliance when not
in use.
•
Pull the plug (not pull Mains Lead)
to disconnect from mains socket.
•
Do not immerse the Motor Body
in water.
Faults and damage
•
If the Jug is chipped or cracked
•
If the Mains Lead has been
damaged in any way.
•
If the Blender appears to be
faulty or damaged in any way
•
Do not switch on or attempt to
operate. Please contact Judge
Customer Services, for address see
Guarantee Section. Never attempt
to repair to the appliance
yourself
•
Please keep your purchase receipt.
