Blender with Glass Jug
Cautions
Before Use
•
Check that your mains power supply
corresponds to the voltage shown in this
manual (also shown on the rating plate,
located under the Motor Body ).
•
Do not connect the Plug into
your socket with wet hands.
•
Ensure that the Mains Lead is not near
any hot surface, and is not in a position on
the worktop where it could be ‘snagged’. The
Mains Lead should not hang over the side of the
worktop, where it could accidentally snagged
or pulled by children. There is a cord shortening
facility located under the Motor Body .
•
Do not move the appliance around
by pulling the Mains Lead .
•
Inspect the Jug to ensure it is free from
chips or cracks - these could cause the
Jug to break during use causing injury.
•
Always keep the appliance out
of the reach of children.
•
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities or
lack of experience or knowledge, unless
they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
•
This appliance is not intended to be
operated by means of an external timer
or a separate remote-control system.
•
The appliance should only be used as
instructed: there is potential
for injury from misuse.
•
Never mount the Cutter Blade Assembly
onto the Revolving Spigot
without the Jug attached.
•
Never leave the appliance unattended
while it is operating.
•
The Jug and Lid must be securely
locked in position before operating the
machine: do not attempt to defeat
the safety interlock mechanisms.
•
Do not use any other jug or parts other
than those supplied with the appliance.
In Use
•
Do not attempt to remove
the Jug or Lid while
the machine is working.
•
Do not operate the motor
when the Jug is empty.
After Use
•
Ensure the Cutter Blade
Assembly has come to a
complete stop before removing
the Lid from the Jug .
•
Always disconnect the electricity
supply before removing
the Jug from the Motor
Body , or approaching any
part that moves in use.
•
Do not use fingers to scrape
food away from the Cutter
Blade Assembly . A plastic
scraper may be used, but only
when the electricity supply
has been disconnected.
•
Care must be taken handling
the sharp blades when
assembling, emptying the Jug
and during cleaning.
•
Unplug the appliance
when not in use.
•
Pull the plug (not pull Mains Lead)
to disconnect from mains socket.
•
Do not immerse the Motor
Body in water.
Faults and damage
•
If the Jug is chipped or cracked
•
If the Mains Lead has
been damaged in any way.
•
If the Blender appears to be
faulty or damaged in any way
•
Do not switch on or attempt
to operate. Please contact
Judge Customer Services, for
address see Guarantee Section.
Never attempt to repair to
the appliance yourself
•
Please keep your purchase receipt.
