User Manual
5
800.321.6221
GuestCall Paging, Coaster Pagers
Model Number: J1707, J1708
Range Test
Turning this feature on and walking around with your pagers will give you an idea of the range of your transmitter.
Transmitter will send a signal to the pagers for this range test. Pagers will light up each time that the pagers receive
the message from the transmitter.
When testing range, use 3 pagers to ensure that you have the most accurate reading. When you have reached a point
where ALL 3 pagers do not receive 2 consecutive pages then you are out of range.
Performing Range Test
>
Scroll to RANGE TEST.
>
Press ENTER key. Transmitter will send page to all pagers every 10 seconds.
Smart Charger Re-Programming
With the Smart Charger, you can renumber pagers back into sequential order as well as ensure that all pagers have the same
configuration.
Program Pagers
The pagers will be set to the programming applied prior to shipping as well as renumbering the pagers into sequential order.
>
The first pager on the charger will be renumbered to the number shown on the charger’s display.
>
Pagers stacked above will renumber based on the pager number on the coaster below it.
>
To activate the programming cycle.
o
PRESS and HOLD the PROG button on the charger for eight (8) seconds.
o
Charger will beep twice indicating that the cycle has begun.
o
You will see the pagers perform several functions as it applies each of the pager configurations. When the
process is complete, all pagers will be in sequential order.
>
NOTE: Replacements for lost pages will arrive with the number 888 on the display.
Replacement of Lost Pagers
Replacements for lost pagers will arrive with the number
8 8 8
on the display.
>
Place new pagers on the stack above a current pager and use the PROG function listed above to have them work with
your existing system.
