User Manual
2
800.321.6221
GuestCall Paging, Coaster Pagers
Model Number: J1707, J1708
Components
Your GuestCall
®
Coaster paging system is comprised of:
>
Transmitter (IQ Base / Istation)
>
The GuestCall Coaster Pagers
>
The GuestCall Coaster Pager Charger
Quick Setup
>
Lock the antenna to the connector on the transmitter by placing the antenna on the connector and twisting
left to lock in place.
>
Plug the power supply into the transmitter and then into a standard 110-240v outlet. A surge protector is
recommended.
>
Compile charger bases and plug charger power supply into charger and then into a standard outlet. Surge
protection is recommended for charging bases.
>
Add pagers to charger slots. You will see a BLUE light on each pager. This light indicates the charging status.
o
‘
LO
’ on the number display: Battery is below 20% charged and SHOULD NOT currently be used.
o
Flashing BLUE
: Pager is charging and CAN BE available for use.
o
Solid BLUE
: Pager is fully charged.
o
Allow 4 hours for a complete charge of the pagers.
System Use
Distributing a Pager
>
Remove a pager from the charger.
>
The pager will flash and vibrate to preview what the alert will look like for the guest.
>
Hand the pager to the guest, stating that the pager will go off with they have been paged.
Paging a Guest
>
To page a guest, enter the 1 to 4-digit pager number into the transmitter and press SEND.
>
The pager will alert until it is returned to the charger.
Setup is Complete
If you have any additional questions, please contact us at the addresses below.
System Configurations
