JRC NQA-1951A, Инструкция по эксплуатации

Страница: 9 / 37

B B
Install the device driver software Install the device driver software JRC HSD PPP JRC HSD PPP
in the terminal connected to DTE port in the terminal connected to DTE port
YES YES
NO NO
YES YES
NO NO
Prepare the attached floppy disk saving Prepare the attached floppy disk saving
device driver software device driver software
TEST TEST
End End
Result? Result?
Check Check
OK OK
NG NG
*2 *2
*1 *1
To setup NQA-1951A with AT commands , Connect PC installing terminal communication To setup NQA-1951A with AT commands , Connect PC installing terminal communication
software to DTE port, and then see software to DTE port, and then see Appendix A: AT command Appendix A: AT command ..
Terminal communication software is as Hyperterminal in Windows. Terminal communication software is as Hyperterminal in Windows.
*2 *2
The setting of NQA-1951A and HSD will be tested by connecting to user’s final destination on The setting of NQA-1951A and HSD will be tested by connecting to user’s final destination on
HSD communication. HSD communication.
The terminal connected to DTE port The terminal connected to DTE port
is used to access to ISP ? is used to access to ISP ?
The terminal connected to DTE port is used The terminal connected to DTE port is used
for PC - PC communication with V120 protocol ? for PC - PC communication with V120 protocol ?
Prepare the attached floppy disk install- Prepare the attached floppy disk install-
ing device driver software ing device driver software
Install the driver software Install the driver software JRC HSD V120 JRC HSD V120
in the terminal connected to DTE port in the terminal connected to DTE port
See “3.3 Setting up device See “3.3 Setting up device
driver software” driver software”
See “3.3 Setting up device See “3.3 Setting up device
driver software” driver software”