&R[n]
Set Control of RI signal
&R0
RI signal is turned to On by bell-signal turning to On
&R1
RI signal is permeated DTE terminal through HSD terminal
&R2
RI signal is always Off
&R?
View current value setup by
&R[n]
&S[n]
Setup control of DSR signal
&S0
DSR signal is always On
&S1
DSR signal set to On at turning CD to On
&S?
View current value setup by
&S[n]
&T=x
Register the trailer for dialing. X: Trailer for dial
&T?
View contents registered by
&T=x
&W[n]
Save active configuration in profiled. Range of [n] is from 0 to 1.
&W?
View current value setup by
&W[n]
&Y[n]
Select active configuration initialized for every turning power on.
Range of [n] is from 1 to 2.
&Y?
View current value setup by
&Y[n]
&Z=x
Register dial number dialed by DTR
&Z?
View contents registered by
&Z=x
The following command is not prefix
AT
.
Command Name
Description
AT
Attention Command
RETURN key
or Enter Key
Execute the command
+++
Return to on-line command mode
Execute the last command again. This command does not require pressing
ENTER key or RETURN key to execute.
A /
Numeric Result Code Alphabetic Result code
Description
0
OK
Complete executing the command
1
CONNECT
the connection is successful
2
RING
Notification of an incoming call
3
NO CARRIER
the connection is unsuccessful
4
ERROR
Incomplete executing the command
7
BUSY
Remote modem is busy
Numeric / Alphabetic Result codes
The
V0
command causes the NQA-1951A to return numeric result codes with
V1
causing the NQA-1951A to return
alphabetic result codes.
