Dip switch to set the address (1-4) and to select the power supply for button backlight (5 and
6).
Connector for external power supply for backlight (24 VDC).
Figure 8: Type plate on the bottom of the console
5.6 Operation Instructions
Power-on
After power-on, the STATUS/RESET-button will lit up and the console starts establishing connection to the main unit.
Light goes off when connection is established and other buttons start working. If there is active fault in system the button
will lit up immediately again.
Making Announcement
Paging zones are selected with zone buttons (usually green). Selected zones are lit up. Selection can be removed by
pressing selected zone button again, or removing all selections at once by pressing reset briefly.
When zones are selected, paging is started from PUSH TO TALK-button by keeping it pressed
1. During prefix, the PUSH TO TALK-button is blinking.
2. When PUSH TO TALK-button is lit up, microphone is open.
71 | AlphaAnnounce Control Panel
