Transmitter/Receiver
Battery Charging
G8
Note
: It is imperative that you fully charge both the
transmitter and the receiver battery packs prior to
each trip to the field. To do so, leave the charger
and batteries hooked up overnight (16 hours). The
first charge should be approximately 20–24 hours
in order to fully charge both battery packs to peak
capacity.
The charger supplied with this system is designed
to recharge your batteries at a rate of 65mAh for the
transmitter and 150mAh for the receiver battery pack.
Transmitter Only
The center pin on all JR® Remote Control Systems is
negative. Therefore, the center pin on all JR chargers is
negative, not positive. This is different from many other
manufacturers’ chargers and radio systems. Beware of
improper connections based on “color-coded” wire leads,
as they do not apply in this instance. You must make
sure that the center pin of your JR transmitter is always
connected to the negative voltage for correct polarity
hookup.
Important
: Please note that the charging polarity of
the transmitter and receiver are different.
Charger
The pilot lamps should always be on during the charging
operation. If not, check to make sure that both the
transmitter and receiver are switched off.
Do not use the charger for equipment other than JR. The
charging plug polarity may not be the same. Equipment
damage can result.
Do not use other manufacturers’ after-market accessories
that plug into the transmitter’s charging jack if you are
unsure of compatibility issues with your radio. Seek
expert advice to avoid possible damage.
During the charging operation, the charger’s temperature
is slightly elevated. This is normal.
CENTER
PIN IS
NEGATIVE
OUTSIDE IS POSITIVE
CHARGER PIGTAIL FOR RECEIVER
CHARGER PIGTAIL FOR TRANSMITTER
BLACK TO POSITIVE
RED TO NEGATIVE
RIGHT SIDE OF TRANSMITTER
RED–POSITIVE / BROWN–NEGATIVE / ORANGE–SIGNAL
