IMPORTANT CCPM PROGRAMMING GUIDELINES
It is extremely important that the travel adjustment values for the three CCPM servos (aileron, elevator, AUX 1) be initially set to exactly the
same travel value. If the travel value is not similar for each servo, it will create unwanted pitching and rolling of the swashplate during collective
pitch inputs. The travel values for each servo will be adjusted in Steps 3-7 and 3-8 to remove any minor pitch and roll coupling during pitch, roll,
and collective movements.
Minor travel value adjustments are necessary due to slight variations in servo travel and centering. Although the three servos may appear to
travel at the same amounts in each direction, in reality the servos can vary slightly. This variation is more common in analog type servos. If JR’s
new digital servos are used, the travel adjustment values will generally not need to be altered.
A. TRAVEL ADJUST
B. SERVO REVERSING
[SWASH TYPE]
3SERVOS(120•)
EXP
AILE
ELEV
PITCH
[NH
-70%
+70%
-65%
ENTER
SEL
ACT
+
–
CL
+
–
CL
+
–
CL
To reverse the direction of a CCPM control function it’s neccessary
to change the value from + to – or – to + as needed.
[SWASH MIX]
3servos
120
•
AILE
+70%
ELEV
+70%
∞ PIT.
-65%
24
It is also extremely important that the servo reversing directions for the three CCPM servos (aileron, elevator, AUX 1) be set as indicated in the
previous radio programming steps. If one or more servos is not set to the correct direction, the CCPM function will be out of synchronization, and
the three control functions (aileron, elevator, collective) will not move properly. In the event that a control surface is working in the wrong
direction, the control function can only be reversed by changing the desired CCPM value for that function from a + to a - value or vise versa.
Example:
If, when you increase the collective pitch, the pitch of the main blades actually decreases, it will be necessary to access the CCPM
function and change the travel value for this function from + to - or - to +. This will reverse the direction of the collective pitch function without
affecting the movement of the aileron and elevator functions.
mix
C
P
6
- 65
%
mix
C
P
3
+ 70
%
mix
C
P
2
+ 70
%
The JR 120° CCPM system requires the use of three servos to operate, aileron, elevator, and AUX 1(Pitch). The labeling of these servos can
become quite confusing because with the CCPM function, the three servos no longer work independently but rather as a team, and their functions
are now combined. For this reason, we will refer to the three servos in the following manner:
Aileron Servo:
“Left” servo (C); the channel number is CH2 when using a JR radio
Elevator Servo:
“Front” servo (A); the channel number is CH3 when using a JR radio
AUX 1 (Pitch) Servo:
“Right” servo (B); the channel number is CH6 when using a JR radio
Please refer to the CCPM connections chart below for clarification. For non-JR radios, please consult your radio instructions for proper connection.
C. CCPM SERVO CONNECTIONS
JR 10 Series
JR 8103
JR 652
GEAR
7 CH 72MHz FM SLIMLINE
RECEIVER
ABC&W INTERFERENCE
PROTECTION SYSTEM
BA
TT
RUDD
E L E V
A I L E
THRO
AUX1
R700 Receiver
Antenna
G460T Gyro (Optional)
(JRPG460T)
G460T
Right
Pitch (B)
Rudder
Front Elevator (A)
Left Aileron (C)
Throttle
