Z2 Controller Operations Manual
Interoperability Now
6-21
Z2C Installation and Operation Manual
indicate it is no longer sending or receiving audio with other members of its net. If the
channel is being monitored in the Monitors Area, it will continue to be monitored. If the
channel is a Monitor in the Monitors Area, it will cease monitoring for the duration of the
two-way communications and will be grayed out.
6.4
Live Status Information
Various small status indicators can appear in the upper right corner of the icons in a Z2 Controller
system. These draw from the same set of indicators employed by the RSP-Z2. Currently, the only
two states for the JPS Bridge and JPS RoIP Channels used in the Z2C are the green dot and no
dot at all. If there is no dot, the channel is idle for one of the reasons listed in the table. The green
dot indicates
Active, Connected.
Below is the full list of the small status indicators that can be present in the upper right of the
channel icons in RSP-Z2 and Z2 Controller systems:
Status
Image
Call State
Unknown
N/A; status at start-up [see also below]
Idle
none
Ended, Incoming, Bye, Timeout, Unable to Connect, Unable to Set Up,
Channel Active
Processing
Dialing, Disconnecting
Link Established
Ringing
Ringing, Far End Ringing
Active
Connected
Error
Busy, Decline, Failed Authentication, Fast Busy, No Answer, No
Connected Device, No Dial Tone, No DNS, Unavailable
Offline
Channel Inactive, headset channel w/o headset plugged in at boot up
Disabled
Any unknown/unexpected
Table 6-1 Live Status Indicators