As soon as you have finished, you
begin to prepare the cables for the
output.
For that, you need again the cables
with the bigger diameter and strip
down about 5 mm on both sides.
Attach forked cable lugs on both sides.
Now you can install the fan from the inside
of the case. For this, four nuts must be
plugged in from the back into the fan and
four screws must be screwed from the
outside of the case to mount the fan.
After the cables are connected and the fan
is mounted, you can install the small board
with two nuts at the case.
If the small board is installed, you can plug all
cables in.
First, mount the cable for the input voltage
(“IN+“ and “IN-“).
Next, mount the cable for the
output voltage
(“OUT+“ and “OUT-“).
The end of the cable from the output voltage must
be conntected with the ports in the front.
